KD0015 kidsbits Blocks Coding L9110 Motor Fan Module

1. Description

kidsbits blocks coding L9110 fan module is fully compatible with kidsbits control board and Lego building blocks.

You can easily connect it to kidsbits control board for communication using an RJ11 cable without worrying about wrong wiring and damage.

The module comes with a high-quality propeller that can easily blow out the lighter flame 20cm away when turning.

Combined with the expansion board, we can use it to make a fire fighting robot. Add flavor to your own interesting projects with this module.

2. Technical Parameters

  • Interface: EASY plug
  • Operating voltage: DC 5V
  • Propeller diameter: 75mm

3. Hookup Guide

4. Import kidsbits Library

Begin with the Mixly blocks coding, you should first import the corresponding kidsbits library for those sensor modules.

Connect the control board to your computer using a USB cable.

Then open the Mixly blocks software 0.998, set the board to UNO R3, select your correct COM port. On the upper right corner you can switch the language.

After that, click Import, import the keyes-kidsbits library. Shown below.

If import custom library successfully, you should see the sensor module library.

Click on the digital read block of keyes_kidsbits, you can directly drag out the corresponding module to use.

5. Test Code

Open or directly drag the Mixly code of touch sensor to the Mixly window.

Check the C language code:

6. Test Result

Hook it up and upload the code success, you should see the motor fan rotating forward for 3 seconds, stop for 2 seconds and then turning reverse for 3 seconds, repeatedly and alternately.

7. Resources Download

https://drive.google.com/open?id=1mwwtGVSn9wMvtvpA_-k7MFuaXN3UwbsP

Leave a Comment