1. Description
kidsbits blocks coding active buzzer module is fully compatible with kidsbits control board and Lego building blocks.
You can easily connect it to kidsbits control board for communication using an RJ11 cable without worrying about wrong wiring and damage.
Here is the simplest sound making module. You can use high/low level to drive it. Just change the frequency it buzzes, you can hear different sound.
It is really great for integrating into projects with this small but useful module.
Have a try! You will find the electronic sound it creates so fascinating.
This module is widely used on your daily appliance, like PC, refrigerator, phones, etc.
2. Technical Parameters
- Interface: EASY plug
- Operating voltage: DC 5V
- Control signal: digital signal
3. Hookup Guide
4. Import kidsbits Library
Begin with the Mixly blocks coding, you should first import the corresponding kidsbits library for those sensor modules.
Connect the control board to your computer using a USB cable.
Then open the Mixly blocks software 0.998, set the board to UNO R3, select your correct COM port. On the upper right corner you can switch the language.
After that, click Import, import the keyes-kidsbits library. Shown below.
If import custom library successfully, you should see the sensor module library shown below.
Click on the Control output block of keyes_kidsbits, you can directly use the corresponding module.
5. Open Code
Open the code folder we provided, or you are able to directly drag the code to Mixly window.
You can click the Code or click the right side arrow to check out the code language.
6. Test Result
Hook it up and upload the code success, active buzzer will make an audible beep for one second then stop, repeatedly.
7. Further Learn
