kidsbits blocks coding dual color LED module is fully compatible with kidsbits control board and Lego building blocks.
You can easily connect it to kidsbits control board for communication using an RJ11 cable without worrying about wrong wiring and damage.
The module is mainly composed of 5mm red and green COM cathode LED lights.
It can be applied to MP3, earphone, digital camera, communication, computer, charger electronic toys and many other fields.
2. Technical Parameters
- Interface: EASY plug
- Operating voltage: DC 5V
- LED drive mode: COM Cathode
- Luminous color: green and red
3. Hookup Guide
4. Import kidsbits Library
Begin with the Mixly blocks coding, you should first import the corresponding kidsbits library for those sensor modules.
Connect the control board to your computer using a USB cable.
Then open the Mixly blocks software 0.998, set the board to UNO R3, select your correct COM port. On the upper right corner you can switch the language.
After that, click Import, import the keyes-kidsbits library. Shown below.
If import custom library successfully, you should see the sensor module library.
Click on the digital read block of keyes_kidsbits, you can directly drag out the corresponding module to use.
5. Test Code
Open or directly drag the Mixly code of touch sensor to the Mixly window.
Check the C language code:
6. Test Result
Hook it up and upload the code success, LED on the module is flashing red for 0.5 second, green for 0.5 second, then off for 0.5 second, repeatedly and alternately.
7. Resources Download