1. Description
kidsbits blocks coding 7-color flicker LED module is fully compatible with kidsbits control board and Lego building blocks.

You can easily connect it to kidsbits control board for communication using an RJ11 cable without worrying about wrong wiring and damage.
The LED module is mainly made of F5MM colorful light-emitting diode.
When we input high power to the signal end (S), the LED on the module will give off three colors of light, namely pink, yellow and green, which will produce a colorful effect in the tri-color flashing.
2. Technical Parameters
- Interface: EASY plug
- Operating voltage: DC 5V
- Output signal: digital signal
- Luminous colors: pink, yellow and green (high brightness)
- Lens type: white mist
3. Hookup Guide

4. Import kidsbits Library
Begin with the Mixly blocks coding, you should first import the corresponding kidsbits library for those sensor modules.
Connect the control board to your computer using a USB cable.
Then open the Mixly blocks software 0.998, set the board to UNO R3, select your correct COM port. On the upper right corner you can switch the language.

After that, click Import, import the keyes-kidsbits library. Shown below.


If import custom library successfully, you should see the sensor module library.

Click on the digital read block of keyes_kidsbits, you can directly drag out the corresponding module to use.

5. Test Code

Open or directly drag the Mixly code of touch sensor to the Mixly window.

Check the C language code:

6. Test Result

Hook it up and upload the code success, LED on the module flickers for five seconds then off for two seconds, repeatedly and alternately.

7. Resources Download
https://drive.google.com/open?id=1PGA7tJI2KYhsGHh0qeNxnvpH9RDJ_gvU